English
Español
12 To 48 cores doom heat shrink seal fiber optic splitter closure 1 inlet 3 outlet
Read More
1. Don't be lazy. After finishing the work every day, take three to five minutes to do a simple cleaning, remove the debris that can be seen, and remove the dust on the surface of the machine.
2. Avoid excessive vibration during use.
3. Pay attention to waterproof and moisture-proof. Especially in summer when it is relatively humid, if the meter has not been used for a long time, be sure to pay attention to moisture-proof, and the board and high-voltage package will be burned out. If possible, put a desiccant in the box.
12 To 48 cores doom heat shrink seal fiber optic splitter closure 1 inlet 3 outlet
12 To 48 cores doom heat shrink seal fiber optic splitter closure 1 inlet 3 outlet
Description:
Optical Splice Closures Are Used To Distribute, Splice, And Store The Outdoor Optical Cables Which Enter And Exit From The Ends Of The Closure. There Are Two Connection Ways: Direct Connection And Splitting Connection. They Are Applicable To Situations Such As Overhead, Man-Well Of Pipeline, Embedded Situation Etc. Comparing With Terminal Box,The Closure Requires Much Stricter Requirement Of Seal. Sealing Ring And Air Valve Are Required For Closure, But That Are Not Necessary For Terminal Box.
Features:
1). High Quality PPR Material Optional, Can Ensure Harsh Conditions Such As Vibration, Impact, Tensile Cable Distortion And Strong Temperature Changes.
2). Solid Structure, Perfect Outline, Thunder, Erosion And Adding Resistance.
3). Strong And Reasonable Structure With Mechanical Sealing Structure, Can Be Opened After Sealing And Cab Be Reused.
4). Well Water And Dust Proof, Unique Grounding Device To Ensure The Sealing Performance, Convenient For Installation.
5). The Splice Closure Has A Wide Application Range, With Good Sealing Performance, Easy Installation, Produced With High Strength Engineering Plastic Housing, With Anti-Aging, Corrosion Resistance, High Temperature And High Mechanical Strength And So On.
4. The lens and reflective lens must be kept clean at all times, and the force must be soft when wiping to avoid cleaning scratches.
5. The parts of the machine itself have rubber pads, which must not be wiped with alcohol, so as not to affect its tightness.
6. Discharge and charge the machine as fully as possible. That is, the battery is charged by photoelectric consumption, and it is fully charged when charging, which can maintain the activity of the battery and prolong its service life and discharge intensity.
7. It is recommended that four to five thousand cores of electrodes should be replaced. In many cases, splicing 810,000 cores seems to work well, but it is easy to cause incorrect discharge, destroy the electrode holder or high-voltage package, and the gain outweighs the gain.
8. Regularly use the inspection and optimization software that comes with the machine system to perform machine self-inspection and optimization. In order not to let the machine do small work under heavy load due to unreasonable settings. Increased wear on the machine.
